美國GE模塊IC754VGB06CTD

廈門圣企機電設備有限公司

代工:15159233533（微信）

固話:0592-6081295

QQ:2587258111

輔助觸頭:與斷路器主電路分、合機構機械上連動的觸頭,主要用于斷路器分、合狀態的顯示,接在斷路器的
控制電路中通過斷路器的分合,對其相關電器實施控制或聯鎖。例如向信號燈、繼電器等輸出信號。塑殼斷路
器殼架等*額定電流100A為單斷點轉換觸頭,225A及以上為橋式觸頭結構,約定發熱電流為3A殼架等*額定
電流400A及以上可裝兩常開、兩常閉,約定發熱電流為6A。操作能次數與斷路器的操作能總次數相同
觸頭:用于斷路器事故的觸頭,且此觸頭只有當斷路器脫扣分斷后才動作,主要用于斷路器的負載出
現過載短路或欠電壓等故障時而自由脫扣,觸頭從原來的常開位置轉換成閉合位置,接通輔助線路中的指
示燈或電鈴、蜂鳴器等,顯示或提酲斷路器的故障脫扣狀態。由于斷路器發生因負載故障而自由脫扣的機率不
太多,因而觸頭的壽命是斷路器壽命的1/10。觸頭的工作電流一般不會1A
分勵脫扣器:分勵脫扣器是一種用電壓源激勵的脫扣器,它的電壓與主電路電壓無關。分勵脫扣器是一種遠距
離操縱分閘的附件。當電源電壓等于額定控制電源電壓的70%-110%之間的任一電壓時,就能可靠的分斷斷
路器。分勵脫扣器是短時工作制,線圈通電時間一般不能15,否則線就會被燒毀。塑殼斷路器為防止線圈燒
毀,在分勵脫扣線圈串聯一個微動開關,當分勵脫扣器通過銜鐵吸合,微動開關從常閉狀態轉換成常開,由于
分勵脫扣器電源的控制線路被切斷,即使人為的按住按鈕,分勵線圈始終不會再通電這就避免了線圈燒損情況
的產生。當斷路器再扣合閘后,微動開關重新處于常閉位置
欠電壓脫扣器:欠電壓脫扣器是在它的端電壓降至某一規定范圍時,使斷路器有延時或無延時斷開的一種脫扣
器,當電源電壓下降(甚至緩慢下降)到額定工作電壓的70%至35%范圍內,欠電壓脫扣器應運作,欠
扣器
在電源電壓等于脫扣器額定工作電壓的35%時,欠電壓脫扣器應能防止斷路器閉合;電源電壓等于或大于85%欠
電壓脫扣器的額定工作電壓時,在熱態條件下,應能*證斷路器可靠閉合。因此,當受保護電路中電源電壓發
生一定的電壓降時,能自動斷開斷路器切斷電源,使該斷路器以下的負載電器或電氣設備免受欠電壓的損壞
使用時,欠電壓脫扣器線圈接在斷路器電源側,欠電壓脫扣器通電后,斷路器才能合閘
為滿足軌道應用的需求條件,GE為您提供了完整系列的接觸器、電動機保護開關和小型線路斷路器。所有這
些元件都含特殊樹脂,符合未來的prEN455452標準的要求。已獲得多項認證例如U和csA等),可以在范圍內廣
泛運用。美國GE模塊IC754VGB06CTD美國GE模塊IC754VGB06CTD

IC200MDL741CA OUT 24VDC POS .5A ESCP 16PT CONF COAT

IC200MDL741LT OUTPUT 24VDC POS LOGIC 0.5A PER PT (1 GROUP OF 16) W/ESCP 16PT (LT)

IC200MDL742 Output 24VDC POS LOGIC 0.5 amp per point(2 group of 16) with ESCP 32 points

IC200MDL742LT OUTPUT 24VDC POS LOGIC 0.5A PER PT (2 GROUPS OF 16) W/ESCP 32PT (LT)

IC200MDL743 Output 5/12/24VDC NEG LOGIC 0.5A per point (1 group of 16) 16 points

IC200MDL743LT OUTPUT 5/12/24VDC NEG LOGIC 0.5A PER PT (1 GROUP OF 16) 16PT (LT)

IC200MDL744 Output 5/12/24VDC NEG LOGIC 0.5A per point (2 groups fo 16) 32 points

IC200MDL744LT OUTPUT 5/12/24VDC NEG LOGIC 0.5A PER PT (2 GROUPS OF 16) 32PT (LT)

IC200MDL750 Output 12/24VDC POS LOGIC 0.5A per point (2 groups of 16) 32 points

IC200MDL750CA Conformal Coated Output 12/24VDC POS LOGIC 0.5A per point (2 groups of 16) 32 points

IC200MDL750LT OUTPUT 12/24VDC POS LOGIC 0.5A PER PT (2 GROUPS OF 16) 32PT (LT)

IC200MDL930 Output relay 2.0 amps per point isolated form A, 8 points

IC200MDL930CA OUT  RELAY 2A ISO FORM A   8PT conf coat

IC200MDL930LT OUTPUT RELAY 2.0A PER PT ISOLATED FORM A 8PT (LT)

IC200MDL940 Output relay 2.0 amps per point isolated form A, 16 points

IC200MDL940CA OUTPUT RELAY 2A ISO FORM A 16PT MODULE ConFORMAL COATED

IC200MDL940LT OUTPUT RELAY 2.0A PER PT ISOLATED FORM A 16PT (LT)

IC200NAL110 10 point PLC, (6) 12VDC in, (4) Relay Out, (1) Analog Input (0-10VDC, 8 bit), 12VDC Power Supply

IC200NAL211 10 point PLC, (6) 24VDC In, (4) Relay Out, (1) Analog Input (0-10VDC, 8 bit), 24VDC Power Supply

IC200NAL211-24 Qty 24, 10 point PLC, (6) 24VDC in, (4) Relay Out, (1) Analog Input (0 -10VDC, 8 bit), 24VDC Power Supply

IC200NDD010 10 point PLC, (6) 12VDC In, (4) 12VDC Out, 12VDC Power Supply

IC200NDD101 10 point PLC, (6) 24VDC In, (4) 24VDC Out, 24VDC Power Supply

IC200NDR001 10 point PLC,(6) 24VDC In, (4) Relay Out, 24VDC Power Supply

IC200NDR001-24 Qty 24, 10 point PLC, (6) 24VDC In, (4) Relay Out, 24VDC Power Supply

IC200NDR010 10 point PLC, (6) 12VDC In, (4) Relay Out, 12VDC Power Supply

IC200PBI001 Remote I/O Profibus DP network interface unit

IC200PBI001CA Remote I/O Profibus DP network interface unit conformal coated.

IC200PKG001 PLC starter kit CPU001

IC200PKG010 VersaMax Modular PLC starter kit.  Kit includes CPUE05.

IC200PKG101 I/O starter kits, Genius NIU

IC200PKG102 I/O starter kit Profibus-DP NIU

IC200PKG103 I/O starter kit DeviceNet NIU

IC200PKG104 VersaMax Ethernet NIU starter kit with I/O.

IC200PNS001 PROFINET Scanner (PNS) module interfaces a remote node of VersaMax modules to a PROFINET IO Controller. Two 10/100 Mbps copper interfaces. Requires Proficy Machine Edition 7.0

IC200PNS001CA Conformal Coated. PROFINET Scanner (PNS) module interfaces a remote node of VersaMax modules to a PROFINET IO Controller. Two 10/100 Mbps copper interfaces. Requires Proficy Machine Edition 7.0

IC200PNS002 PROFINET Scanner (PNS) module interfaces a remote node of VersaMax modules to a PROFINET IO Controller.  Two 100Mbps Multi-Mode fiber (MMF) ports.  Requires Proficy Machine Edition 7.0.

IC200PNS002CA Conformal Coated.  PROFINET Scanner (PNS) module interfaces a remote node of VersaMax modules to a PROFINET IO Controller.  Two 100Mbps Multi-Mode fiber (MMF) ports.  Requires Proficy Machine Edition 7.0.